England's most complete Regency town is conveniently less than a hundred miles from London and an ideal base for touring into the Cotswolds, Stratford upon Avon and Bath.
Most of the town centre lies within a conservation area of outstanding national importance. Regency town houses , characterised by intricate ironwork balconies and painted stucco facades, line the historic Promenade, squares and terraces. With its award-winning gardens, impressive range of stylish shops and restaurants, and its festivals of horse racing, music and literature, Cheltenham has a cosmopolitan ambience to beguile the most jaded spirit.
Whatever your interests, contact us for knowledgeable, comprehensive and impartial advice to enable you to make the very most of your visit to Cheltenham.
posted by Excitingspas
@ 1:48 AM
permanent link |
|
0 comments
0 Comments:
All spas that I am aware of will have some sort of air plumbing. Some hot tubs use passive air intakes only and some will use a forced air system or "blower". Most tubs will use check valves to keep water from backing up into the air lines, and will place a portion of the air plumbing above the water line, the reason this is done is, that water that backs up into the air lines can cause the spa to leak from the air intakes, or venturies, where the air is adjusted in and out of the jets, and in systems that use air blowers, water that gets into the air blower will short the system out and cause the GFCI to trip. Some manufacturers maintain that they will not use air blowers because they are problematic in tubs where the water level goes too high. (Like when there are several people in the tub). And that they offer limited therapeutic value, and that they cause the power consumption to increase due to the fact that blowing air through the water in such volumes causes faster heat loss. All these things are true. My suggestion here is that with this information in mind, you test drive a tub with an air blower, keeping in mind that they do not have to be used all the time, and see if the benefits outweigh the potential problems for you.
There are two typical ways to plumb an air blower into a spa. One is to use an "air channel" this is a "U" shaped channel that is adhered to the shell which then has holes drilled into it allowing air to pass up into the water when the blower is turned on and fills the air channel. This gives a larger disbursement of air through the tub, than the second method "air injectors" but if not done properly air channels can be problematic.
Problems associated with air channels, can be, they do not always fill completely and if this is the case some of the holes may not bubble. This condition can come on with time if calcium or other foreign bodies get into or form in the holes and / or channel. In a freeze situation an air channel can break away from the shell and lead to an expensive repair. Water will lie in an air channel without circulating, and once the disinfectant in this water is used up this can lead to bacteria growth, or mold growth where there are air pockets trapped. This condition can lead to water that is harder to maintain and / or foul smelling air from the air channel.
The second method is to use "air injectors". This is where small air lines run from a manifold to individual air injectors that are placed throughout the spa shell, and while they tend to be cleared of water more efficiently than air channels, the water in them does not circulate, so they can be prone to the same bacteria and mold problems that air channeled spas are. Also by adding more glue joints there is more potential for leaks, secondary to improper gluing at the time of manufacture.
Also, without circulation these areas can be more prone to freezing than other plumbing parts in the tub, if the heater fails.
posted by Excitingspas
@ 3:28 PM
permanent link |
|
1 comments
1 Comments:
-
This was the second time when I availed the services of Aames Plumbing for my house. It was an air conditioner problem when I called them for the very first time. I was so impressed with their service that when my heater broke down, I had no better name in my mind than to call Aames Plumbing. This time also, they didn't let me down.
A spa bath is a 'self-contained body of warm water designed for sitting rather than swimming in,which has a mechanism to ensure the water flows around the user'. It is designed for a small number of people to use at one time. The water temperature is kept between 30 to 40 degree celcius, and is not usually drained between users, so has to be continually filtered and cleaned. A hydrojet circulation or air induction bubble system is used to stir up the water.
You may also call your spa bath a spa pool, hot spa, hot tub, portable spa, or whirlpool spa (a term commonly used in American publications). 'Jacuzzi' is the trade
name for one type of spa bath.
posted by Excitingspas
@ 4:02 PM
permanent link |
|
0 comments
0 Comments:
Cancer treatment is usually superb, until it's over - then you are handed pills to take for the next five years. 95% of cancer sufferers have side effects; everyone's different, but medics don't have time to deal with them. Spa treatments have been known to help alleviate many of the side effects.Verite Reily-Collins, a respected journalist writing from her own experience, has set up a new website "After Cancer" with support from helpful companies to give information about medically-approved products (especially for dry, itchy skin) and treatments (such as massage) that are given to patients in France, Germany, USA etc (where survival rates are better), and available in Britain - if we know what to ask for.
posted by Excitingspas
@ 2:42 AM
permanent link |
|
0 comments
0 Comments:
The Public Pools and Spas unit is responsible to: 1)Inspect water quality and filtration at existing pools and spas . 2)Verify that safety equipment, proper fencing or other enclosures and signage are provided and maintained . 3)Provide public information and training about proper pool operation and maintenance . 4)Inspect the facilities for physical conditions that conform to state regulations . 5)Provide for the review of engineering drawings and plans for proposed public pools or water recreation facilities . The unit also works to keep public beach areas safe for swimmers.
posted by Excitingspas
@ 3:55 PM
permanent link |
|
0 comments
0 Comments:
Systems serving showers and hand basins should deliver water at less than 43 degree celcius, to prevent scalding. The main boilers should be maintained at temperatures not below 60 degre celcius, to prevent colonisation by Legionella bacteria. The temperature reduction required can be achieved by mixing valves.
Tepid water systems (or modified tepid water systems that keep temperatures below 60 dgree celcius) must be maintained in accordance with the Health (Legionella) Regulations 2001. Instantaneous hot water systems can be controlled to provide water at these ranges, without the need for storage or mixing valves.
posted by Excitingspas
@ 2:47 PM
permanent link |
|
0 comments
0 Comments:
Types of Facilities and Required Means of Entry into the Water1)Swimming Pools
Large pools must have a minimum of two accessible means of entry. A large pool is defined as any pool with over 300 linear feet of pool wall. Pool walls at diving areas and in areas where swimmers cannot enter because of landscaping or adjacent structures are still counted as part of the pool's total linear feet. The primary means of entry must be either a sloped entry into the water or a pool lift that is capable of being independently operated by a person with a disability. The secondary means of entry could be a pool lift, sloped entry, transfer wall, transfer system, or pool stairs. It is recommended that where two means of entry are provided, they be different types and be situated on different pool walls. Pools with less than 300 linear feet of pool wall are only required to provide one accessible means of entry, which must be either a pool lift or sloped entry. 2)Aquatic Recreation FacilitiesWave action pools, leisure rivers, sand bottom pools, and other pools where access to the water is limited to one area and where everyone gets in and out at the same place, must provide at least one accessible means of entry, no matter how many linear feet of pool wall is provided. The accessible means of entry can be either a pool lift, sloped entry, or transfer system. 3)Catch PoolsA catch pool is a body of water where water slide flumes drop users into the water. An accessible means of entry or exit is not required into the catch pool. However, an accessible route must connect to the edge of the catch pool. 4)Wading PoolsA wading pool is a pool designed for shallow depth and is used for wading. Each wading pool must provide at least one sloped entry into the deepest part. Other forms of entry may be provided as long as a sloped entry is provided. The sloped entries for wading pools are not required to have handrails. 5)SpasSpas must provide at least one accessible means of entry, which can be a pool lift, transfer wall, or transfer system. If spas are provided in a cluster, 5 percent of the total-or at least one spa-must be accessible. If there is more than one cluster, one spa or 5 percent per cluster must be accessible. Footrests are not required on pool lifts provided at spas. However, footrests or retractable leg supports are encouraged, especially on lifts used in larger spas, where the water depth is 34 inches or more and there is sufficient space.
posted by Excitingspas
@ 9:29 AM
permanent link |
|
0 comments
0 Comments:
Accessible pool stairs are designed to provide assistance with balance and support from a standing position when moving from the pool deck into the water and out. ADAAG provisions for stairs include the requirement that all steps have uniform riser heights and uniform tread widths of not less than 11 inches, measured from riser to riser. Additionally, open risers are not permitted. Other stairs or steps provided in the pool are not required to meet these guidelines.Handrails:
Pool stairs must have handrails with a minimum width between the rails of 20 inches and a maximum of 24 inches. The 20- to 24-inch width for the accessible pool stairs is intended to provide support for individuals with disabilities who are ambulatory. Handrail extensions are required on the top landing of the stairs but are not required at the bottom landing. Handrails on pool stairs must comply with ADAAG provisions. The top of the handrail gripping surface must be a minimum of 34 inches and a maximum of 38 inches above the stair nosing. If handrails are mounted on walls, the clear space between the handrail and wall must be 1.5 inches.
posted by Excitingspas
@ 11:02 AM
permanent link |
|
0 comments
0 Comments:
If water play components are provided, they must comply with the Access Board’s Play Area Guidelines and accessible route provisions.If the surface of the accessible route, clear floor or ground spaces, and turning spaces that connect play components are submerged, the accessible route does not have to comply with the requirements for cross slope, running slope, and surface conditions. Transfer systems may be used instead of ramps to connect elevated water play components.
posted by Excitingspas
@ 1:06 PM
permanent link |
|
0 comments
0 Comments:
1) Prevent the water temperature from exceeding 104 degree Fahrenheit (40 degree Celsius). 2) Exclude children less than five years old from using spas. 3)aintain a locked safety cover for the spa when possible. 4)ecommend that all pregnant women consult a physician before spa use, particulary in the first rimester. 5)revent entrapment injuries with appropriate drain design and configuration.
posted by Excitingspas
@ 11:53 AM
permanent link |
|
1 comments
1 Comments:
-
Your hot tub or home spa can be a source of entertainment and relaxation for years - but only if you use it safely.
Regards,
Hot Tub Safety
Pool lifts must be located where the water level is not deeper than 48 inches. This provides the opportunity for someone to provide assistance from a standing position in the water if desired. If multiple pool lift locations are provided, only one must be where the water is less than 48 inches. If the entire pool is deeper than 48 inches, an exception allows operators to use a pool lift in any location as an accessible means of entry.
posted by Excitingspas
@ 1:16 PM
permanent link |
|
1 comments
1 Comments:
-
With the high pressure hydraulic powered access , you are able to use a fairly light weight system that consumes a relatively small amount of power to move objects around.
A robotic massage chair is a chair that contains internal electronic motors and gears designed to massage the person sitting in them. Most robotic massage chairs have some form of controller to vary the type, location, or intensity of massage. Massaging chairs most frequently resemble recliners. There are many different types and brands, including office-style chairs that operate from internal batteries. A less expensive option is a separate massaging pad that may be used with an existing chair. Some popular brands are Omega, Takemi Select, Kyokei, Human Touch, Panasonic, SHSS, OSIM, OTO, VGO, OGAWA. Massaging chairs vary tremendously in price, style and intensity, from cheap "vibrate only" chairs to full intensity Shiatsu models for people who require as close to a real invigorating massage as possible.
posted by Excitingspas
@ 9:42 AM
permanent link |
|
0 comments
0 Comments:
It is located in an airport and specializes in short treatments aimed at the traveler, like 15-minute chair massage and oxygen therapy. Some also offer longer treatments. The very first airport spa was created on November 17, 2000 at Newark Liberty International airport Terminal C located in the U.S. state of Newark, New Jersey. This concept was pioneered by Gina Stern, President of departure spa.
posted by Excitingspas
@ 4:08 PM
permanent link |
|
0 comments
0 Comments:
| |
|
This was the second time when I availed the services of Aames Plumbing for my house. It was an air conditioner problem when I called them for the very first time. I was so impressed with their service that when my heater broke down, I had no better name in my mind than to call Aames Plumbing. This time also, they didn't let me down.